Remington PG6030 - Remington Groomer Usage: Advanced Tips and Cleaning; Tips for Optimal Trimming Results; Attachment Usage Guide; Groomer Cleaning After Use

5
ENGLISH
ETips for best results
Comb your hair in the direction that it grows so that the hairs are at their maximum height and
facing in the same direction.
After trimming, lightly go over the trimmed areas with the foil to get a smooth clean nish.
Since all hairs do not grow in the same direction, you may want to try dierent trimming
positions (i.e. upwards, downwards or across) for better results.
,Attaching and removing the trimmer attachments.
Note: Always ensure the groomer is switched o before changing any attachments.
• To remove, hold the groomer with one hand and turn the trimmer head anti-clockwise
with the other.
• To attach, hold the groomer with on hand and turn the trimmer head clockwise with the
other.
,Using the detailed trimmer
• Hold groomer with the surface (back side) of the blade guides against the skin.
• Use motions similar to using a wet blade to provide the closest trim.
Note: This attachment provides a dual purpose solution for stubble or close results
without irritation.
,Using your miniscreen shaver
• Hold the groomer so the MiniScreen gently touches your face.
• Use short, and well-controlled movements to shave around your beard/moustache. Use
your free hand to stretch your skin. This encourages the hair to stand upright, making it
easier to shave.
Note: The MiniScreen shaver was designed to shave the detail areas around your beard
moustache/sideburns. It was not designed to shave your entire face. For a close
comfortable shave, guaranteed, use one of Remington’s electric shavers.
C CARE FOR YOUR GROOMER
Care for your product to ensure a long lasting performance. We recommend that you clean your
groomer after each use.
The easiest and the most hygienic way to clean the groomer is by rinsing the product head after
use with warm water. Always keep the protective cap on the shaving head and keep the trimmer
in the “o” position when the shaver is not in use.
E After each use
• Rinse the accumulated hair from the cutters and shake o excess water. Alternatively, use
a brush.
• Gently tap on a at surface to remove hair particles, and brush the remaining hairs away.
• Place one or two drops of cutter oil or sewing machine oil on the blades. Turn the clipper
on to distribute the oil evenly, wipe o any excess oil.
• Wipe the main unit with a damp cloth and dry immediately.
Note: Ensure that the groomer is turned o when applying
the oil or rinsing under the tap.