Remington Power X Series - Clipper Care and Cleaning Procedures; Remington HC3000 GP Specifications and Disposal; Battery Removal Procedure

6
STEP 4  TOP OF THE HEAD
• Use the longer length comb attachment and set it to 24 mm then cut hair on top of the
head against the direction in which the hair normally grows.
• Always work from the back of the head.
STEP 5  THE FINISHING TOUCHES
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades lightly touching
the skin and then work downwards.
CARE FOR YOUR HAIRCLIPPER
• Your clipper is tted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Always keep the attachment guide comb on the trimmer blade.
AFTER EACH USE
• Ensure the appliance is switched o and unplugged from the charger before cleaning.
• Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
• To clean unit, wipe with a damp cloth and dry immediately.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o excess oil.
WASHABLE BLADE CLEANING
• The blades are washable under a running tap but must be removed before they are
cleaned in this way. Keep the body of the device dry at all times.
• Take out the hex screws and disassemble the blade set. Brush and clean out
accumulated hair. Oil the contact surfaces of the blades and then reassemble.
CLEANING CAUTIONS
• Do not use harsh or corrosive cleaners on the units or their blades.
• Ensure the appliance is switched o and unplug from the main outlet before cleaning.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the device until it stops.
2. Pry o and remove the top panel.
ENGLISH