To Next Page
J
Jodi MorrisonJul 29, 2025
What to do if the Remington Edger line does not feed?
- WWayne GreenJul 29, 2025
If the line on your Remington Edger isn't feeding when you tap the line advance button, here are a few things to check: * You may have used all the line on the spool. * The line might have retracted into the spool. * The line could be caught or tangled on the spool. To resolve this, you may need to install a new line on the spool, remove the spool and pull the line out, or remove the spool, loosen, and untangle the line.
General