6
5. Leave the head assembly open to let the shaver dry completely.
6. Return the shaving head to its original position and snap in place.
Note:
• Ensure that the shaver is turned off when cleaning.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and
cutters heads.
• Rinse only with cool or warm water, not hot water. Do not rinse with
water hotter than 70°C.
REPLACING THE FOILS & CUTTERS
Signs that your foils and cutters need replacing:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may
feel the cutters pulling on your hair.
Wear: You may notice that the cutters have worn through the foils.
To ensure the continued highest quality performance from your shaver, we
recommend that foils and cutters are replaced every 6 months.
To Replace The Foil
Note: Ensure the shaver is switched off.
1. Remove the shaver head.
2. Gently push the small plastic tabs area at either end of the foil carrier.
The foil carrier should then easily detach from the shaving head.
3. To reassemble, snap the new foil carrier into position.
4. Attach the shaving head.
Caution:
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.
new foil
tabs
To Next Page
Loading...
