Remington SF4880 - Replacing Trimmers & Cutters; Signs Trimmers Need Replacing; Replacing the Head Assembly

6
, REPLACING THE INTERCEPT TRIMMERS & CUTTERS
• To ensure continued high quality performance from your shaver, we
recommend the intercept trimmers and cutters are replaced every 12
months.
, SIGNS THAT YOUR INTERCEPT TRIMMERS AND CUTTERS NEED
REPLACING
• Irritation: as intercept trimmers get worn, you may experience skin
irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the
intercept trimmers
, REPLACING THE INTERCEPT TRIMMERS & CUTTERS
• Remove the shave head assembly by grasping the front and back of the
shave head and lifting the assembly upwards from the hair pocket.
• Insert the new shave head assembly on the hair pocket, press down and click
into place.
• Intercept trimmers and cutters replacement model: SPF-SF4880
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the mains supply when removing
the battery.
• Using a small screwdriver, pry o the 2 side panels.
• Using a screwdriver remove the 4 screws from the front of the shaver and
remove the front housing.
• Using a screwdriver, remove 8 screws from the front of the shaver.
• Remove and open the core from the shaver to expose the batteries.
• Cut the wires connecting the batteries to the circuit board and remove the
batteries.
• The battery is to be disposed of safely.