ENGLISH
2
INSTRUCTIONS FOR USE
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, press and hold the on-off switch until the LCD lights up to switch the
straightener on.
When the LCD temperature display reaches the desired temperature the styler is ready
to use.
For extra protection and best results, section hair prior to straightening and spray with
heat protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.
Take care not to hold your hand over the temperature setting switches while styling, as
this could lead to altering the temperature by mistake.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when
using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
090179 REM IFU S2024 UK.indd 2 24.03.09 18:50
PROTECT THE ENVIRONMENT
For further information on recycling see www.remington-europe.com
Do not dispose of the product in household waste at the end of its life. Disposal can take place at
the Remington® Service Centre or appropriate collection sites.
To Next Page
Loading...
