Daily Cleaning:
1. Locate the detachment grooves on the head & cutter assembly. Gently
pull to detach the hair pocket from the neck assembly. (Diagram H)
2. Tap out excess hair shavings.
3. Rinse the head of the shaver in running water.
4. Gently reattach the hair pocket to the neck assembly until it locks in
place on all three sides. The hair pocket may be reattached in any
configuration.
Weekly Cleaning:
1. Locate the detachment grooves on the head & cutter assembly. Gently
pull to detach the hair pocket from the neck assembly. (Diagram H)
2. Tap out excess hair shavings
3. Slide the blue cutter support frame upwards towards the direction of
the two cutters to release it from the assembly. (Diagram I)
4. Lift and remove the cutter support frame away from the cutters.
5. Remove the cutters. (Diagram J)
6. Thoroughly rinse away any debris from inner and outer cutters with
warm water.
7. Replace the inner cutters. (Diagram K) The inner and outer cutters are
colour coded (grey, blue and black) to ensure each cutter is returned to
its original and most effective position on the cutter assembly.
8. Hold the cutter support frame with the raised center section facing
upwards. Place it over the cutters so that the centre mouth opening is
facing the blue cutter. Slide the cutter carrier towards the blue cutter
until the locking tab locks under the centre triangle. (Diagram L)
9. Lubricate each cutter with Remington Shaver Saver (SP4).
10. Gently reattach the hair pocket to the neck assembly until it locks in
place on all three sides. The hair pocket may be reattached in any
configuration. (Diagram M)
12
To Next Page
Loading...
