Remington T Series - Attachments; T-Blade Attachment Fitting and Removal; Fixed Guide Combs Usage; Adjustable Stubble Comb

5
• To preserve the life of your batteries, recharge them for 4 hours at least every 6
months.
• On a full charge, your trimmer will run for up to 5 hours of cordless usage.
CORDED USE
• Connect the charging adaptor to the product then to the mains.
• The charging lights will come on.
TRAVEL LOCK
• Your trimmer has a travel lock which helps to preserve the battery charge during
storage.
• To lock, slide the travel lock to the locked ( L) position.
ATTACHMENTS
TO FIT AND REMOVE TBLADE ATTACHMENT FIG. A
Ensure that the device is switched o before tting or removing attachments.
• To remove, slide the attachment forwards with your thumb. The foil shaver has a
release button which must be pressed before it can be slid o.
• To t, slide the attachment onto the body until it clicks into place.
FITTING AND REMOVING FIXED GUIDE COMBS FIG. B
To Fit
• Hook the front of the guide comb over the teeth of the T-blade.
• Press the back of the guide comb down until it clicks into place.
To Remove
• Lift the tab on the back of the guide comb upwards until it comes free from the
T-blade.
ADJUSTABLE STUBBLE COMB
• Fit the adjustable stubble comb in the same way as you would t a xed guide comb.
• The 1.5 - 5 mm comb can be adjusted by turning the wheel to the desired setting.
Turn the wheel clockwise for longer length and anticlockwise for shorter length.
• The indicator on the wheel will point to the chosen setting.
• Use the trimmer without the adjustable comb for trimming hair close to the skin.
This will trim hair to 1.0 mm, holding the blades perpendicular to the skin will trim
hair to 0.5 mm.