Remington WDF4840 - Replacing Foil and Cutters; Signs of Wear; How to Replace Foil; How to Replace Cutters

6
• Donotrinsewithwaterhotterthan70°C.
• Donotcompletelysubmergetheladyshaverinwater.
• Donotcleantheshavingfoilswiththebrush.
• Atregularintervals,putadropofsewingmachineoilontothefoilsand
cutter heads.
, Replacing your Foil and Cutters
To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced every 6 months. These can
be obtained from our nearest Remington* Service Centre.
, Signs that your foils and cutters need replacing:
• Irritation:Asfoilsgetworn,youmayexperienceskinirritation.
• Pulling:Asthecutterswear,yourshavermaynotfeelascloseandyoumay
feel he cutter pulling your hair.
• Wear through:Youmaynoticethatthecuttershavewornthroughthefoils.
, To Replace the Foil
• Ensuretheladyshaverisswitchedo.
• Gentlypushthesmallplasticareaateitherendofthefoil.Thefoilshould
then easily detach from the head assembly.
• Toreassemble,slidethefoilintofoilbracketandclickintoposition.
• Closetheheadassembly.
, CAUTION
• Onlyholdtheplastictopreventdamagetothefoil.
• Donotpressonthefoilwhenreplacing.
, To Replace the Cutters
• Ensuretheshaverisswitchedoandopentheheadassembly(asabove).
• Toremovecutter,graspcutterbetweenthethumbandforengerandpull
upwards.
• Toreassemblecutter,placecutterontotheoscillatortip.Gentlypushdown
clicking into position.
BATTERY REMOVAL
• Thebatterymustberemovedfromtheappliancebeforeitisscrapped.
• Theappliancemustbedisconnectedfromthesupplymainswhenremoving
the battery.
• Removetheshaverheadfromtheunit.