Remington WDF4840 - Replacing Foil and Cutters; Signs of Wear; How to Replace Foil; How to Replace Cutters

6
• Donotrinsewithwaterhotterthan70°C.
• Donotcompletelysubmergetheladyshaverinwater.
• Donotcleantheshavingfoilswiththebrush.
• Atregularintervals,putadropofsewingmachineoilontothefoilsand
cutter heads.
, REPLACING YOUR FOIL AND CUTTERS
• Toensurethecontinuedhighestqualityperformancefromyourshaver,we
recommend that the foil and cutter are replaced every 6 months. These can
be obtained from our nearest Remington* Service Centre
, Signs that your foils and cutters need replacing.
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling:asthecutterswear,yourshavemaynotfeelascloseandyoumayfeel
the cutter pulling your hair.
• Wearthrough:youmaynoticethatthecuttershavewornthroughthefoils.
, TO REPLACE THE FOIL
• Ensure the lady shaver is switched o.
• Gentlypushthesmallplasticareaateitherendofthefoil.Thefoilshould
then easily detach from the head assembly.
• Toreassemble,slidethefoilintofoilbracketandclickintoposition.
• Closetheheadassembly
, CAUTION
• Onlyholdtheplastictopreventdamagetothefoil.
• Donotpressonthefoilwhenreplacing.
, TO REPLACE THE CUTTERS
• Ensuretheshaverisswitchedoandopentheheadassembly(asabove).
• Toremovecutter,graspcutterbetweenthethumbandforengerandpull
upwards.
• Toreassemblecutter,placecutterontotheoscillatortip.Gentlypushdown
clicking into position.
< BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• Theappliancemustbedisconnectedfromthemainssupplywhenremoving
the battery.
• Removetheshaverheadfromtheunit.
ENGLISH