Remington X5 Power-X Series - Getting Started; Charging Your Appliance; Charging Methods

4
PARTS
1. Blade set
2. On/O/Turbo Switch
3. Length adjustment dial
4. Length setting window for 25 - 35 mm
comb
5. Length setting window for 14 - 24 mm
comb
6. Length setting window for 3 - 13 mm
comb
7. Charging indicator light
8. Charger connector
9. 25 - 35 mm comb
10. 14 - 24 mm comb
11. 3 - 13 mm comb
12. Micro fade adjustable comb
Not Shown:
• Adaptor
• Cleaning brush
• Oil bottle
GETTING STARTED
CHARGING YOUR APPLIANCE
• Before using your hairclipper for the rst time, charge for 2 hours.
• Ensure the product is switched o.
• Connect the charging adaptor to the product and then to the mains.
• When charging, the charge indicator light will light up. The light will go out when
charging is complete.
• If the product is not going to be used for an extended period of time (2 – 3 months),
unplug it from the mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• Allow 2 hours for a complete charge.
• To preserve the life of your batteries, let them run out every 6 months then fully charge.
• The clipper comes with a quick charge function, 10 minutes charging will give an
emergency burst of run time.
CHARGING VIA STANDARD ELECTRICAL SOCKET
• Ensure the product is switched o.
• Connect the charging adaptor to the product and then to the mains.
USB
• Connect Micro USB to the appliance, and the USB connector to any standard USB port
or charger
• Product will only charge through USB and will not run in corded mode.
CORDED USE
• Connect the charging adaptor to the product then to the mains.
CAUTION Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
• When the product is switched on and fully charged it can be used in cordless mode for
up to 75 minutes.