To Next PageTo Next Page
Need help?Do you have a question about the REMIS REMIFLAIR IV and is the answer not in the manual?
General| Brand | REMIS |
|---|---|
| Model | REMIFLAIR IV |
| Category | Window Blinds |
| Language | English |
Verify all components are present, including cassette, coffer, and guiding profiles.
Install guiding profiles into cassette corners and secure cords to support feet.
Position frame, mark, secure cassette holders, and attach frame to aperture.
Close system to determine lower mounting points and screw in support legs.
Pull both handle bars down as far as possible to close the insect protection.
Grasp handle bars centrally and drag them to the desired position to close the blackout.
Push both handle bars up as far as possible to open the system.
Tighten or loosen roller blind tension using a screwdriver in the frame corner.
Adjust plissé tension by loosening/tightening grub screws in cord clamps.
Clean frame with a moist cloth and mild soapy water; plissé and insect protection carefully.
Obtain spare parts from an authorised dealer and keep user information accessible.
