ii
Failure to follow the SAFETY RULES may result in serious personal injury.
INSTALLATION
* GROUND THE RECEIVER CASE. In order to insure safety of the system, the
receiver case must be firmly connected to earth ground.
* PROVIDE A SAFETY CUTOFF SWITCH. If maintenance is required, the radio
must be disconnected from power to prevent accidental activation.
* USE PROPER WIRING. Loose or frayed wires can cause accidental activation of
machinery.
* DO NOT INSTALL IN HOT AREAS. This apparatus can be damaged by heat in
excess of 160 F.
* DO NOT INSTALL IN HIGH VIBRATION AREAS. The life of this apparatus may
be shortened through long exposure to intense shaking or vibration.
* DO NOT INSTALL IN AREAS WHERE WATER OR CONTAMINENTS CAN
ENTER THE RECEIVER. The receiver is enclosed in a NEMA 12 rated enclosure,
however direct spraying of liquids or exposure to caustic environments may result in
malfunction of the unit.
PERSONAL SAFETY
* MAKE SURE MACHINERY IS CLEAR BEFORE OPERATING. Do not activate
the remote system unless it is safe to do so.
* TURN OFF THE RECEIVER POWER BEFORE WORKING ON MACHINERY.
Always disconnect the remote system before doing any maintenance to prevent accidental
operation of the machine.
CARE
* KEEP DRY. If water or other liquids get inside, immediately dry the unit.
* KEEP ANTENNAS CLEAN. Keep antenna connections clean and free of corrosion.
WARNING !
READ ALL INSTRUCTIONS
WARNING INSTRUCTIONS
To Next Page
Loading...