10- Do not install the ice machine in a damp location where it may come in contact.
Deteriorated insulation on electrical parts may cause an electric shock or fire.
11- In order to keep the lubricant fully precipitated before start up, please keep the machine
upright for 24 hours before plugging to prevent compressor damage.
Danger information
1-The Ice machine may contain flammable refrigerant R-290 that risk fire and explosion. Please
contact your local authority in regard to safe disposal of this product. Please check the nameplate
on the rear panel of machine to identify the type of refrigerants to confirm the refrigerant type
and amount.
2-To minimize the risk of ignition due to improper installation, replacement part or service
procedures, only certified and properly trained refrigerator technicians are allowed to work on
these ice machine.
3-Do not operate the ice
machine if there are any unauthorized change to the
original manufactures specifications or if the machine has been misused, abused or
neglected.
4-All replacement parts must be use obtained from the equipment manufacturer.
5-Due to potential safety hazard risk, make sure that the power plug is not
crushed or damaged. Do not use the ice machine with an extension cord.
Installation information
Unpacking
- Carefully remove all shipping material such as wrapping, tape and packing, if any is left in the
ice machine it will cause the machine to work improperly. (Make sure the packing is in good
condition before unpacking.)
- After removing the packing make sure the machine and all components are in good
condition. If any doubt, do not install or use the ice machine and contact to your supplier
immediately.
- Put the ice machine on the floor and screw the four adjustable feet into the bottom of the
ice machine. A level should be use to check the machine is perfectly level.
Risk of fire or explosion! Do not
use mechanical devices to defrost
the machine,do not puncture the
cooling tube
To Next Page
Loading...