1.57
X = Seat not suitable for fitting child seats ISOFIX.
IUF/IL = On equipped vehicles, seat which allows an approved “Universal/semi-universal” or “vehicle specific” child seat to be at-
tached using the ISOFIX system; check that it can be fitted.
(1) A carrycot can be installed across the vehicle and will take up at least two seats. Position the child with his or her feet nearest
the door.
(2) If necessary, position the vehicle seat as far back as possible. Move the front seat as far forward as possible to install a rear-
facing child seat, then move back the seat in front as far as it will go, although without allowing it to come into contact with the
child seat.
(3) In all situations, remove the rear headrest of the seat on which the child seat is positioned. This must be done before fitting the
child seat. Please refer to the information on the “Rear headrests” in Section 3. Move the seat in front of the child forwards,
move the seatback forward to avoid contact between the seat and the child’s legs.
(4) Push the seat(s) in front of the child in a third row seat as far forward as possible.
CHILD SEATS: attachment using the ISOFIX system (6/6)
To Next Page
Loading...
