FLUENCE Z.E. – Roadside assistance technician's guide
RENAULT PROPERTY Network Development Division | February 2012 V3|
37
c. Loading a Fluence Z.E. which has broken down onto a tow dolly.
" This recovery configuration is not authorised for a Fluence Z.E. which
has been damaged in an accident
" Make sure no-one is in the immediate vicinity when the vehicle is being loaded.
" Position the recovery vehicle as close to and in line with the vehicle to be recovered and proceed as
follows:
• Comply with the recommended recovery configurations shown above
• Deploy the arm as close as possible to the broken down vehicle
• To facilitate the movement of a broken down vehicle with jammed wheels, use a jack to raise the
vehicle and place it on one or more dollies
• Adjust the front mobile spindles on the L/R tow dollies according to the wheel diameter of the
broken down vehicle
• Adjust the space between the two tow dolly forks according to the track width of the vehicle being
loaded, and respecting the recovery vehicle's centre line
• Position the vehicle to be towed in the tow dolly
• Raise the vehicle with the tow dolly and make sure that a distance remains between the body of the
arrow and the front of the vehicle being towed
• Release the handbrake
• Place the gear lever in position N (neutral)
• Set the steered wheels straight and in line with the recovery vehicle
• Lock the steering
• Remove the keys from the ignition
• Place the keys outside the vehicle
• Adjust the height of the tow dolly ready for transportation, ensuring that the ground clearance is at
least 350 mm (see illustration page 36)
• Secure the broken down vehicle on the tow dolly (see illustration page 38)
• Affix the legally required signs to the rear of the vehicle being recovered
To Next Page
Loading...
