2.102
ENG_UD71465_2
Régulateur de vitesse (XFK - Renault)
CRUISE CONTROL (3/5)
Exceeding the cruising speed
The cruising speed may be exceeded
at any time by depressing the accelera-
tor pedal.
While it is being exceeded, the cruising
speed flashes in red on the instrument
panel. Then, release the accelerator
pedal: after a few seconds, the vehicle
will automatically return to its set cruis-
ing speed.
Cruising speed cannot be
maintained
If driving up or down a steep gradi-
ent, the system is unable to maintain
the cruising speed: the stored speed is
flashes red on the instrument panel to
inform you of this situation.
Adjusting the cruising speed
The cruising speed may be changed by
pressing the following repeatedly:
– the 2 switch (SET/-) to reduce the
speed;
– the 3 switch (RES/+) to increase the
speed.
Note: press and hold one of the
switches to modify speed by succes-
sive increments.
If the cruise control is no
longer available (after sev-
eral attempts to activate
it), contact an Approved
Dealer.
2
3
Temporarily not available
The system controls accelera-
tion and deceleration of your vehi-
cle using the engine and braking
system. The system activates the
brakes in order to maintain the set
speed, the system applies limited
braking. In the event of a steep de-
scent, for example in a mountainous
area, you must select a lower gear
to benefit from engine braking.
To reduce the load imposed on the
braking system and to prevent the
brakes from overheating, the cruise
control function may be temporar-
ily interrupted and the message
“Check Cruise Control” may appear.
The message disappears when the
function becomes available again.
If the message remains, contact an
approved dealer.
To Next Page
Loading...
