operating faults ..........................................
(current page)
3.21
ENG_UD71812_2
Lève-vitres électriques (XFK - Renault)
When closing the windows,
ensure that no part of the
body (arm, hand, etc.) is
protruding from the vehicle.
Risk of serious injury.
One-touch electric window
The one-touch mode works in addition
to the operation of the electric windows
described previously.
It is fitted to the driver’s window.
Briefly press or pull the switch 1 as far
as it will go: the window will be fully
raised or lowered.
1
Operating faults
In case of a fault when closing a
window, the system reverts to normal
mode: pull the switch concerned up as
often as necessary to fully close the
window (the window will close gradu-
ally), hold the switch (still on the clos-
ing side) for one second then lower and
raise the window fully to reinitialise the
system.
If necessary, contact an approved
Dealer.
Pressing the switch again while the
window is moving will stop its move-
ment.
Note: if the window detects resistance
when closing (e.g. tree branch etc.), it
stops and then lowers again by a few
centimetres.
ELECTRIC WINDOWS (3/3)
To Next Page
Loading...
