3.9
AIR CONDITIONING, HEATING: programming (2/2)
Activating the function
– With the ignition on, position the con-
trol 1 in one of the
ṗ positions;
– turn off the ignition. The “COMFORT”
message and the programmed time
are displayed on the instrument
panel for a few seconds;
– wait approximately one minute
before charging your vehicle;
– plug in your vehicle to a power supply
(refer to the information on “Electric
vehicle: charging” in section 1).
The function triggers 30 minutes before
the programmed time to reach a com-
fortable temperature.
Automatically switching off the
function
– About 10 minutes after the pro-
grammed time;
– if the charging socket is discon-
nected;
– if control 1 is not in one of the
ṗ
positions.
4
5
C
D
Setting the start time for the
function
– To programme the start time, use
buttons C and D to navigate through
the menu until message COMFORT
PROG appears.
– hold down button D on stalk 5 - the
hours flash;
– press button C to adjust them;
– hold down button D on stalk 5 - the
minutes flash;
– press button C to adjust them;
– confirm by pressing button D on
stalk 5.
The message “COMFORT PROG” and
the programmed time are displayed on
the instrument panel 4.
To Next Page
Loading...
