5.35
Electrical equipment POSSIBLE CAUSES WHAT TO DO
The wipers do not work. Wiper blades stuck. Free the blades before using the wipers.
Faulty electrical circuit. Consult an approved Dealer.
Fuse damaged. Replace the fuse, refer to the information on
“Fuses”.
The wiper does not stop. Faulty electrical controls. Consult an approved Dealer.
Direction indicators flashing more
quickly.
Blown bulb. Replace the bulb.
The direction indicators do not
work.
Faulty electrical circuit. Consult an approved Dealer.
Fuse damaged. Replace the fuse, refer to the information on
“Fuses”.
The headlights do not switch on or
off.
Faulty electrical circuit or control. Consult an approved Dealer.
Fuse damaged. Replace the fuse, refer to the information on
“Fuses”.
Traces of condensation in the
lights.
This is not a fault. Traces of condensation are a natural phenomenon caused by vari-
ations in temperature.
The traces will disappear slowly once the lights are switched on.
OPERATING FAULTS (4/4)
To Next Page
