1
NU692_7_G1-FRA.qxd 22/10/04 11:16 Page 1.73
J84 - MEGANE SCENIC - NU692-7
C:\Documentum\Checkout\NU692_7_T1-ENG.win 8/12/2004 16:55
-page85
1.73
EXTERIOR LIGHTING AND SIGNALS (continued)
Switching on the main
beam headlights
With the dipped beam headlights
on, pull stalk 1 towards you.
When the main beam headlights are
lit up, an indicator light on the
instrument panel comes on.
To return to the dipped headlight
position, pull the stalk towards you
again.
See-me-home lighting function
This function (useful, for example,
for opening a gate, a garage, etc.),
enables you to momentarily switch
on dipped beam headlights.
With the engine switched off and
the lights off,theendofstalk1 in
position 0, pull stalk 1 towards you:
the dipped beam headlights light up
for approximately thirty seconds.
This action may be carried out no
more than four times for a
maximum lighting period of two
minutes.
To switch off the lights before they
switch off automatically, turn the
end of stalk 1,thenreturnitto
position 0.
Turning off the lights
Manual operation
There are two possible ways
(depending on vehicle):
-return stalk 1 to its original
position,
- the lights go out when the engine
is stopped, when the driver's door
is opened or when the vehicle is
locked. In this case, the next time
the engine is started the lights will
be switched back according to the
position of the stalk 1.
Automatic operation (depending
on vehicle)
The lights go out when the engine is
stopped, when the driver's door is
opened or when the vehicle is
locked.
Lights on warning buzzer
If the lights are switched on after the
engine is switched off, a warning
buzzer sounds when the driver's
door is opened to warn you that the
lights are still on.
To Next Page
