2
■ SPECIFICATIONS
■ GENERAL SAFETY INSTRUCTIONS
Model HD200 HD210 HD290 HD300 HD310 HD320
Power 2.2Hp 10A 2.2Hp 10A 3.2Hp 15A 3.0Hp 15A 3.2Hp 15A 3.2Hp 15A
Free Air
Delivery
200LPM 210LPM 290LPM 300LPM 310LPM 320LPM
Tank
Size
65L 65L 75L 75L 75L 95L
Cylinder
Type
V-Twin V-Twin Triple V-Twin Triple Triple
Drive
Type
Belt Belt Belt Belt Belt Belt
Before attempting to operate this air compressor the following basic safety precautions must be taken to
reduce the risk of fire, electric shock and personal injury. It is important to read the instruction manual and
to understand applications, limitations and potential hazards associated with the air compressor. This air
compressor is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
Do not expose your air compressor to rain or use in damp or wet conditions. Keep the work area well lit. Always
ensure your compressor is level and stable. Using your compressor on uneven or unstable ground may cause a
lack of lubrication and the pump to seize, this damage will not be covered under warranty.
Children and pets should be kept out of the work area. Children should not be allowed to touch or operate
the air compressor, tools or extension cords. This air compressor is not designed for use by young children
or infirm persons without supervision. The air compressor and tools should be kept out of reach of children,
preferably stored or locked in a secure cabinet or room when not in use.
Work areas and benches should be kept tidy. Cluttered benches and work areas can cause accidents. Floors
should be kept clean and free from rubbish. Special care should be taken when the floor is slippery due to
sawdust or wax. Always leave sufficient distance, at least 5 metres between the air compressor and the work
area, especially when using tools designed for sanding or spraying liquids.
WORK ENVIRONMENT
Select the right tool for the job. Do not use a tool for a job for which it was not designed.
Do not force a small air compressor to do the job of a heavy duty air compressor. Do not use the air
compressor for unintended purposes. Stationery units should be rubber mounted.
USE THE RIGHT TOOL
BEWARE OF CHILDREN AND PETS
WORK AREA
Avoid body contact with earthed or grounded surfaces (e.g. pipes and refrigerators).
GUARD AGAINST ELECTRIC SHOCK
To Next Page
Loading...