Need help?Do you have a question about the Renegade REN 850S and is the answer not in the manual?
Steps for mounting the amplifier securely and safely, considering vehicle layout.
Details on connecting Ground, Remote, and Battery (+12V) wires for proper amplifier operation.
Connects the amplifier to car stereo or head unit using low-level RCA Cinch outputs.
Sends a full-range audio signal to another amplifier using line output.
Adjusts lower bass frequencies from 0 dB to +12 dB, caution advised.
Adjusts the cut-off frequency for the low-pass range from 40 Hz to 150 Hz.
Limits ultralow frequencies from 15 to 55 Hz to protect the subwoofer.
Guides setting the input level for optimal sound without distortion.
Connects the remote controller for adjusting bass level from the driver's seat.
Connects one subwoofer (2-8 Ohms) to the amplifier's output terminals.
Connects two subwoofers (4-8 Ohms each) to the amplifier's output terminals.
Diagnosing and resolving issues where the amplifier does not power on or operate.
Resolving issues where the amplifier powers on but no sound is produced.
Addressing problems with specific channels not producing sound.
Resolving distorted audio output from the loudspeakers.
Diagnosing and fixing issues related to the absence of bass sound.
Understanding and resolving amplifier protection mode activation.
Identifying and fixing sources of hiss or white noise in the audio signal.
To Next Page
General
