Need help?Do you have a question about the RenewAire HE07 and is the answer not in the manual?
Describes the sequence of operation for the ERV unit with enhanced controls.
Explains the fundamental principles of energy recovery ventilation.
Details temperature sensors, temp/humidity sensors, and their locations.
Explains methods to access and interact with the controller interface.
Outlines the organization and navigation of the controller's menu system.
Sets essential parameters like time, date, units, and IP address.
Confirms unit settings and options after initial setup.
Details the conditions and steps required for initiating unit operation.
Explains available control methods for the supply fan.
Details the control options for the exhaust fan.
Describes the frost control functionality and its enabling conditions.
Explains how to operate the unit with only one fan active.
Covers room sensing, flush cycles, and cold weather operation modes.
View individual I/O values on controller status screens.
Adjust sensor and transducer readings for accuracy.
Explains sensor inputs, digital/analog I/O, and wiring diagrams.
Procedures for handling, viewing, and understanding all types of controller alarms.
Manually control outputs for testing system components.
Troubleshooting common issues, general testing, and parameter management.
Connecting external devices via the micro USB port.
Exporting and viewing alarm and data log files.
Accessing and reviewing controller parameter files.
Procedures for updating controller firmware via USB or Ethernet.
View primary status including SA/CA temperature and other sensor readings.
Check fan status, enabled status, and other operational parameters.
View all available frost control information and status.
Access I/O and version information for the controller.
Setting unit control source and selecting BMS communication protocol type.
Configuring BACnet settings, object lists, application notes, and licensing.
Setup and application notes for Modbus communication protocols.
Monitor and reset unit and fan run hours and start counts for service alerts.
Review details of the last unit power interruption for troubleshooting.
View memory write info and initialize alarms.
Erase retained values or NVRAM settings as directed by support.
Record initial controller settings, setpoints, offsets, and IP addresses.
Log user modifications to settings, offsets, and I/O configurations.
Record any updated controller programs installed by the factory or user.
Track the performance and location of controller system backups.
Adjusting KP and Ti settings for optimal heating/cooling control response.
Step-by-step guide for establishing KP, Ti, and verifying combined settings.
Reference table for temperature sensor resistance values.
Guide to interpreting and using the HE-Series unit configuration codes.
General| Brand | RenewAire |
|---|---|
| Model | HE07 |
| Category | Controller |
| Language | English |
To Next Page
