Renkforce MAC-608 - Time Settings

31
a) Time Settings
Time settings for alarm duration and alarm delay at unauthorised entry or exit are made on the PCBs in
the alarm system casing using the DIP switches marked “T1”, “T2” and “T3” by setting them as follows:
DIP-switch “T1”: Exit delay: Alarm trigger delay can be set between 15 seconds and 4 minutes (only alarm
zones Z1 and Z2)
Jumper position Time
OFF OFF OFF 15 seconds
OFF OFF ON 30 seconds
OFF ON OFF 45 seconds
OFF ON ON 60 seconds
ON OFF OFF 90 seconds
ON OFF ON 2 minutes
ON ON OFF 3 minutes
ON ON ON 4 minutes
DIP-switch “T2” entry delay: Alarm trigger delay can be set between 15 seconds and 4 minutes (only alarm
zone Z1)
Jumper position Time
OFF OFF OFF 15 seconds
OFF OFF ON 30 seconds
OFF ON OFF 45 seconds
OFF ON ON 60 seconds
ON OFF OFF 90 seconds
ON OFF ON 2 minutes
ON ON OFF 3 minutes
ON ON ON 4 minutes