Why is my Reno 300/40 Air Compressor compressing air even though it has reached the working pressure?
If your Reno Air Compressor continues to compress air despite reaching the set working pressure, the pressure switch may be covered with verdigris. The suggested solution is to replace the pressure switch.
Why does air continuously leak from the pressure switch when my Reno Air Compressor is stopped?
If air continuously leaks from the pressure switch of your Reno Air Compressor when it's stopped, it could be due to dirt in the bypass valve. Try cleaning the bypass valve or replacing the rubber fitting in the bypass valve.
What to do if my Reno 300/40 starts and stops frequently?
If your Reno Air Compressor starts and stops frequently, it might be because overdimensioned air tools are being used. Check the air consumption of your tools.
Why is all air drifting out through the pressure switch after air compression in my Reno 300/40?
If all the air drifts out through the pressure switch after air compression in your Reno Air Compressor, it's likely that dirt is stuck in the bypass valve, or the black rubber plug is defective. The suggested solution is to clean the bypass valve or replace the rubber plug.
Why is my Reno Air Compressor very noisy?
If your Reno Air Compressor is excessively noisy, it may be due to using the wrong type of oil. Ensure you are using synthetic compressor oil only. It might be necessary to replace the pump unit.
What to do if my Reno 300/40 Air Compressor does not work 100 %?
If your Reno Air Compressor isn't working at full capacity, a possible cause is a missing phase in the power supply. Open the electricity box on top of the motor and check that all wires are properly connected.
Why is the safety valve activated on my Reno 300/40 Air Compressor even though max pressure has not been reached?
If the safety valve on your Reno Air Compressor activates before reaching the maximum pressure, the safety valve may be defective. Replace the safety valve.
How to fix a Reno 300/40 Air Compressor that leaks oil?
If your Reno Air Compressor is leaking oil, the oil level might be too high. Remove oil through the plug until the oil glass is half full.
General| Brand | Reno |
|---|---|
| Model | 300/40 |
| Category | Air Compressor |
| Language | English |
To Next Page
