Reolink Floodlight PoE - Mount the Floodlight to the Wall; Troubleshooting; Floodlight is not powering on; Specification

English English7 8
1.Drillholesinaccordancewiththemountingtemplate.
2.Securethemountingplatetothewallwiththeuppertwoscrewsandhangtheoodlightonit.
3.Thenlocktheoodlightinpositionwiththelowerscrew.
Mount the Floodlight to the Wall
PoE
RST
DC12V
LAN
RST
DC12V
2
1
1
2
PoE
RST
DC12V
LAN
RST
DC12V
2
1
1
2
PoE
RST
DC12V
LAN
RST
DC12V
2
1
1
2
Troubleshooting
• Make sure your Floodlight is powered on
properly. The PoE Floodlight should be pow-
ered by a PoE switch/injector, a Reolink NVR
or a 12V power adapter.
•IftheoodlightisconnectedtoaPoEdevice
as listed above, connect it to
another PoE port and check again.
• Try again with another Ethernet cable.
If your Floodlight is not powering on, please try
the following solutions:
Floodlight is not powering on
For PoE Floodlight
For WiFi Floodlight
•Plugtheoodlightintoadierentoutletand
see if it works.
•Powerontheoodlightwithanotherworking
12V 2A DC adapter and see if it works.
If the problem is not solved, please contact
Reolink Support.
Specication
Light: 40pcs/18W
Dimension: 216X118X160mm
Weight: 635g
Working Temperature
:
-10°C~+55°C (14°F~131°F)
Hardware Features
Notication of
Compliance
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
this device may not cause harmful
interference, and this device must accept any
FCC Compliance Statement