English3 English 4
VGAHDMIUSB
AUDIO
OUT
DC 48V
ON
2 4 6 8
1 3 5 7
OFF
LAN
eSATA
Connection DiagramCamera Introduction
Before using the camera, please connect your camera as instructed below to finish initial setup.
1. Connect the camera to a Reolink NVR (not included) with an Ethernet cable.
2. Connect the NVR to your router, and then power on the NVR.
* You may also connect the camera to a PoE switch or PoE injector.
NOTE: The camera should be powered with a 12V DC adapter or a PoE powering device such as PoE
injector, PoE switch or Reolink NVR (not included in the package).
PoE IP Camera
Ethernet Cable
Reolink NVR
Router
Ethernet Cable
Power Adapter
Mount
Micro SD Card Slot
Spotlight
Telephoto Lens
IR LED
Daylight Sensor
Wide-Angle Lens
Built-in Mic
Speaker
Waterproof Lid
Network Cable
Power Port(Optional)
Reset Button
* Press for about 10 seconds to restore the
device to factory settings.
To Next Page
Loading...
Need help?
General
