9 10
Install the Camera
• Install the camera 2-3 meters (7-10 ft) above the ground. This height
maximizes the detection range of the PIR motion sensor.
• For better motion detection performance, please install the camera
angularly.
NOTE: If a moving object approaches the PIR sensor vertically, the
camera may fail to detect motion.
You haven't added any device. Please click
the"+"button in the top right corner to add
θ
Mounting Height:
2-3 Meters
PIR Detection Distance:
2-10 Meters
• Do not face the camera towards any light sources.
• Do not point the camera towards a glass window. Otherwise, it may
result in poor image quality because of the window glare caused by
infrared LEDs, ambient lights or status lights.
• Do not place the camera in a shaded area and point it towards a
well-lit area. Otherwise, it may result in poor image quality. To ensure
best image quality, the lighting condition for both the camera and the
capture object should be the same.
• To ensure better image quality, it’s recommended to clean the dome
cover with a soft cloth from time to time.
• Make sure the power port is not directly exposed to water or
moisture and not blocked by dirt or other elements.
• The waterproof camera can work properly under conditions like rain
and snow. However, it doesn’t mean the camera can work underwater.
• Do not install the camera at places where rain and snow can hit the lens
directly.
• The camera may work in extreme cold conditions as low as -25°C.
Because when it is powered on, the camera will produce heat. You may
power on the camera indoors for a few minutes before installing it
outdoors.
Installation Tips
To Next Page
Loading...
Need help?
General
