15 16
If the camera fails to connect to WiFi, please try the following solutions:
• Ensure that you have entered the correct WiFi password.
• Put the camera closer to your router to ensure a strong WiFi signal.
• Change the encryption method of the WiFi network to
WPA2-PSK/WPA-PSK (safer encryption) on your router interface.
• Change your WiFi SSID or password and make sure that SSID is within
31charactersandpasswordiswithin64characters.
• Set your password using only the characters available on the keyboard.
If the problem is not solved, please contact Reolink Support.
Failed to Connect to WiFi During Initial Setup Process
Specication
Infrared Night Vision: Up to 15 Meters
Day/Night Mode: Auto Switchover
FieldofView:Horizontal96°-38°;Vertical:55°-21°
Hardware Features
General
If the picture from the camera is not clear, please try the following
solutions:
• Check the camera dome cover for dirt, dust or spiderwebs. Please clean
the dome cover with a soft, clean cloth.
•Pointthecameratoawell-litarea.Thelightingconditionwillaectthe
picture quality a lot.
•Upgradethermwareofyourcameratothelatestversion.
• Restore the camera to factory settings and check it again.
If the problem is not solved, please contact Reolink Support.
Picture Is Not Clear
Dimension:228*147*129mm
Weight (Battery included): 1.4KG
Operating Temperature: -10°C~+55°C (14°F~131°F)
OperatingHumidity:20%~85%
Notication of Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modicationsnotexpresslyapprovedbythepartyresponsiblefor
compliance could void the user’s authority to operate the equipment.
FCC Compliance Statement
To Next Page
Loading...
Need help?
General
