Repatha Pushtronex - Step 1: Prepare the System; Cartridge Preparation and Acclimation; Infusor Tray Setup

Page 3
●
The single-use on-body infusor for subcutaneous injection is made to only be used
with the prefilled cartridge.
●
Moderate physical activities can be done during the injection process, such as
walking, reaching and bending.
●
Do not use the on-body infusor and prefilled cartridge after the expiration date on
the carton.
●
The on-body infusor and prefilled cartridge are not made with natural rubber latex.
A healthcare provider who knows how to use the on-body infusor should be able to
answer your questions. For more information, call 1-844-REPATHA (1-844-737-2842) or
visit www.REPATHA.com.
Keep the on-body infusor and prefilled cartridge out of the reach of children.
Step 1: Prepare
1A
Remove the
on
-
body infusor
and prefilled cartridge
carton from the refrigerator.
Wait at least 45 minutes before injecting for the on-body infusor and prefilled
cartridge in the carton to naturally reach room temperature.
 Do not try to warm the prefilled cartridge by using a heat source such as
hot water or a microwave.
In any above cases, use a new on-body infusor and prefilled cartridge and call
1-844-REPATHA (1-844-737-2842) or visit www.REPATHA.com.
1B
Open the carton and peel away the white paper cover. Remove the
plastic
cover
from the clear tray.
Clear tray
Prefilled
cartridge
On-body infusor
Plastic cover
Leave the on-body infusor and prefilled cartridge in the clear tray until you are ready to
inject.
●
Do not touch the start button until the on-body infusor is on the skin and you are
ready to inject.
●
Do not use if the white paper cover is missing or damaged.