Need help?Do you have a question about the RepRap Guru Prusa i3 and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Bed Temperature | Up to 110°C |
| Build Volume | 200 x 200 x 180 mm |
| Connectivity | USB, SD Card |
| Software | Repetier-Host, Cura |
| Supported Materials | PLA, ABS |
| Power Supply | 12V, 20A |
| Weight | 8 kg |
| Frame Material | Acrylic |
Configure serial connection, port, baud rate, and printer specific parameters.
Set extruder temperatures, diameter, and print area dimensions.
Configure layer height, perimeters, infill, and speed for slicing.
Configure print speed, travel moves, and acceleration parameters.
Adjust support material settings, raft options, and interface spacing.
Set filament temperature, diameter, and fan cooling parameters.
Define bed size, offsets, and retraction settings for the slicer.
Insert filament into the extruder and manually extrude to check flow.
To Next Page