4
2000 Model 12/24 Volt
SPECIAL MODEL 2000 INSTRUCTIONS:
4000 PEAK AMPS
• Extra Long 62” Cables
• Parrot Clamps
• Dual Heavy Duty 20AH
Instructions
Components
1. Charge this unit in 12V position only.
2. Turn voltage switch on back panel to match the voltage of the battery being
boosted (12V or 24V).
3. Connect RED positive (+) clamp to positive (+) battery terminal or post.
4. Connect the BLACK negative (-) clamp to a non-moving metal part of the engine.
5. If green lights are lit, voltage and polarity are correct.
6. Start your vehicle.
7. Disconnect BLACK negative (-) clamp first, then disconnect the RED positive (+) clamp.
8. Always wrap Jumper Cables securely into place after use.
9. After use, recharge your Jump Pack.
10. Frequently check charge level of battery by pushing the red Battery Level Test
Button
5
on control panel.
Portable Power Pack
To Next Page
Loading...
