Recharging
Recharge every 30 days and after each use. Failure to do so will result in possible damage to the
internal battery and result in poor performance or failure to work at all.
1. Plug the AC Charging Cord supplied into the 120 Volt-in connection on the back of the
Jump Pack.
2. Plug the other end of the cord into a 110/120-volt AC outlet.
3. The Red charging LED light will glow and will remain ON during the charging process
When the internal battery is completely full the Green FULL CHARGE LED light on the
control panel will turn on automatically. This can take up to 72 hours depending on the
condition of your internal battery. You can unplug your AC Charging Cord at this
time OR leave it plugged in indefinitely as the CUL™ listed internal charger is float
charge equipped to maintain the internal battery.
Performance Guidelines
10
CAUTION
CAUTION: The only approved method of recharging is by means of the 110 Volt cord connected to
the unit’s charger. Any other method of recharging could result in damage to the internal circuitry
of the unit.
7
14
6
IMPORTANT: Your BATTERY LEVEL can be at a HIGH CHARGE STATUS when you push
your red Battery Level Test Button . This does not necessarily indicate that the battery is
FULLY CHARGED. To be at the “Full Charge Level” the Green FULL CHARGE light on the
control panel will turn on during the charging process indicating FULL CHARGE status.
For best results when using your Portable Power Pack:
• Clean the battery terminals or posts before connecting the clamps to the vehicle battery. Use
a battery post cleaner brush to remove corrosion from the battery terminals or posts. Two Quick
Cable cleaners are recommended for cleaning terminals, posts and cables. Solutions 510420
and 510430 will neutralize the gray/white powdery corrosive material. (See quickcable.com for
more information).
WARNING
WARNING: Possible explosion hazard. Contact with battery acid may cause severe burns and blindness.
KEEP OUT OF REACH OF CHILDREN.
• Always wear safety glasses when working with or around lead acid batteries.
• If splashed by battery acid, immediately flush the area of the splash with clean water; if a
burning sensation is felt or any blistering occurs, seek medical help. If acid is splashed in
the eyes, flush eyes with clean water continuously and seek medical help.
• All lead acid batteries generate hydrogen gas during normal operation. This process
increases during a rapid discharge period such as when using for jump-starting. Hydrogen
gas and battery acid (sulfuric acid) can be:
• Explosive • Poisonous to breathe
• Corrosive & will burn skin, eyes & hair • Highly flammable
• Damaging to unprotected metals • Damaging to natural fiber clothing
To avoid exposure to battery acid or the possibility of an explosion:
• Follow all instructions in this manual and your vehicle’s manual.
• Only use your Jump Pack in a well-ventilated area.
• Observe all warnings.
www.quickcable.com
Portable Power Pack
To Next Page
Loading...
