22
• WATER FUNCTION: To On/O the water function (ventilation with the
cooling process) press the button . The water function symbol will
appear in the display. The symbol will appear in the display showing
that the injection pump in the water tank is working and the symbol
will appear in the display when the returning pump in the basin is
working.
Note: Before the pump in the water tank starts to inject water, the
returning pump in the basin will work to empty it.
When the fan starts, automatically the water function starts working.
• LACK OF WATER: The control panel has a sensor to detect lack of
water inside of the water tank. When the water level is lower than
minimum, the symbol starts blinking, informing the user needs to
rell the water tank. After lling it, the water function will automatically
be activated.
Note: When the lack of water is detected, the water function will stop.
• FAN SPEED: This R4 Control Panel has 10 speeds controlled by the
buttons O/Decrease and On/Increase. You will note that the fan
reaches its maximum or minimum speed levels when you hear a longer
beep coming from the panel. To turn on, press the button , it will
start automatically in the minimum speed. To increase the speed, keep
it pressed until you reach the desired speed. To turn o, keep pressed
the button until the fan stops.
• OUTTER LIGHT: Press the button to On/O the outter light in the
placard. The symbol will appear in the display to show this function
is on.
• CLOCK TIME ADJUSTMENT: After programming the sleep function,
press again the button , the display will show the current time
blinking. In case you would like to adjust it, use the buttons and .
If you don´t press any button for the next 5 seconds, the display will be
back to the normal.
• REMOTE CONTROL: Except the 5 lamp brightness levels, the remote
control has all functions detailed before plus a command for turning
On/O the fan.
Note: If all the functions are not controlled by the Remote Control,
verify the battery charge. When replacing, use the CR 2025 battery
model.
The temperature indicator reads from -9°C to 50°C. If the display
shows EE then the operation temperature is out of the range or some
disturb may have happened with the sensor.
12 14
8
7
16
17
19
19
17
13
5
17
19
22
23
To Next Page
Loading...
