4
Reassembly
Refer to the reassembly illustrations in this user guide.
Reassembly steps
1. Ensure the cushion is oriented correctly by aligning the top cushion
tab with the recess in the top of the mask.
2. Gently pull the cushion through the front of the mask frame until
the cushion locks securely into the mask frame. The tabs on either
side of the cushion should be sitting against the mask frame.
Ensure the cushion is not twisted or distorted.
3. Attach the top headgear straps to the mask frame by looping onto
each of the upper headgear hooks.
4. Replace the elbow assembly into the air tubing and attach the
combined elbow assembly and air tubing to the mask by pressing
the side-tabs and pushing into the mask.
Cleaning your mask in the home
Your mask and headgear should only be gently handwashed.
Daily/After each use:
• Disassemble the mask components according to the disassembly
instructions.
• Thoroughly clean the separated mask components (excluding headgear),
by gently rubbing in warm (approximately 86°F/30°C) water using mild
soap.
• To optimise the mask seal, facial oils should be removed from the cushion
after use.
• Use a soft bristle brush to clean the vent.
• Inspect each component and if required, repeat washing until visually
clean.
• Rinse all components well with drinking quality water and allow to air dry
out of direct sunlight.
• When all components are dry, reassemble according to the reassembly
instructions.
Weekly:
• Handwash the headgear.
To Next Page
Loading...
Need help?
General
