Reson SeaBat 7125 ROV

Questions and Answers

C
Cynthia DominguezAug 14, 2025
What to do if Reson SeaBat 7125 ROV Sonar shows 'Critical Disk Level' and stops recording?
- D
  davidsonmichaelAug 14, 2025
  If you receive a 'Critical Disk Level' warning and data recording stops on your Reson Sonar, it means the hard drive is almost full or errors have occurred during data recording. Check user permissions, ensure you have enough available disk space, and verify file names and recording directories.
A
Amy NixonAug 18, 2025
What to do if Reson Sonar shows 'DMA Transfer Timeout' error?
- K
  Kristin HerreraAug 18, 2025
  A 'DMA Transfer Timeout' error on your Reson Sonar usually means the uplink from the receiver is interrupted. Check the BITE page for receiver BITE values, restore factory defaults, and reboot the PC.
K
Kevin CruzAug 21, 2025
Why Reson SeaBat 7125 ROV Sonar shows 'Could not create PCI server'?
- M
  Miranda RogersAug 21, 2025
  If your Reson Sonar displays 'Could not create PCI server', it indicates a failure to configure the main data acquisition and distribution module (PCI). This can be due to errors in the configuration files or a corrupted installation. Reboot the PC.
L
Leslie JenningsAug 25, 2025
How to fix Reson SeaBat 7125 ROV Sonar calibration failed: too much noise?
- S
  Sara BlankenshipAug 25, 2025
  If calibration fails on your Reson Sonar due to excessive noise, it means that calibration has failed. You should check the BITE page and hardware and cable installation to the receiver and check environmental noise.
M
Mr. Joseph HolmesAug 27, 2025
What to do if Reson SeaBat 7125 ROV 'Could not create UDP server'?
- L
  lauralewisAug 27, 2025
  If the Reson Sonar displays the message 'Could not create UDP server', it means a network resource was unavailable to the software from the operating system. Check user permissions and network drivers.
I
Ivan RasmussenAug 31, 2025
What to do if Reson Sonar shows 'FATAL: DMA Read size limitation reached'?
- W
  Wayne CastroAug 31, 2025
  If your Reson Sonar shows 'FATAL: DMA Read size limitation reached', it indicates a general error occurred while transferring data to the software. Reboot the system.
H
hnortonSep 3, 2025
How to fix Reson Sonar error '7K Bite File cannot be Read'?
- J
  Julia Lin MDSep 3, 2025
  If the '7K Bite File cannot be Read' error appears on your Reson Sonar, it means the software installation is corrupt. Restore factory defaults and reinstall the software.
M
Mark RussellSep 7, 2025
How to fix Reson Sonar ADMXRC configuration failed?
- K
  kristina09Sep 7, 2025
  If the ADMXRC configuration fails on your Reson Sonar, it means the software failed to detect or configure the primary processing card. Check PCI bus drivers for the ADMXRC card.
B
bentleyrebekahSep 10, 2025
What to do if Reson SeaBat 7125 ROV 'Could not create TCP server'?
- J
  James GuerreroSep 10, 2025
  If the Reson Sonar displays the message 'Could not create TCP server', check user permissions and network drivers.