ALTEA 90/120 WORK ADJUST THE LOCKING CABLE
1. Loosen the locking nut as shown in the picture,
Use a 10mm open end wrench..
2. To have the pin go in more, turn the head of the
cable (turn clockwise ) as showed in the picture ,
using a 8mm open end wrench. By turning the cable,
you are extending the distance the lever can move.
Be careful not to loosen the cable too much, the
cable can become disconnected from the lever.
3. To lock the cable. Hold the head of the cable with
the 8mm wrench while tightening the locking nut.
1. Loosen the locking nut as shown in the picture,
Use a 10mm open end wrench..
HOW TO ADJUST THE LOCKING CABLE FOR MODEL PENELOPE/CIRCE/ALTEA
2. To have the pin go in more, turn the head of
the cable (turn clockwise ) as showed in the
picture , using a 8mm open end wrench. By turning
the cable, you are extending the distance the lever
can move.
Be careful not to loosen the cable too much, the
cable can become disconnected from the lever.
3. To To lock the cable. Hold the head of the cable
with the 8mm wrench while tightening the
locking nut.
1. Loosen the locking nut as shown in the picture,
Use a 10mm open end wrench..
HOW TO ADJUST THE LOCKING CABLE FOR MODEL PENELOPE/CIRCE/ALTEA
2. To have the pin go in more, turn the head of
the cable (turn clockwise ) as showed in the
picture , using a 8mm open end wrench. By turning
the cable, you are extending the distance the lever
can move.
Be careful not to loosen the cable too much, the
cable can become disconnected from the lever.
3. To To lock the cable. Hold the head of the cable
with the 8mm wrench while tightening the
locking nut.
4
To Next Page
Loading...
