Response Shed Alarm ML1

To Next Page

Shed Alarm

User Manual

INTRODUCTION

The Response Shed Alarm is an intruder alarm and chime integrated system, designed to

protect your shed. It is a simple to use, easy to install unit.

Whats included in the pack : What you need to purchase :

1 x Shed Alarm 1 x 9V PP3 Alkaline Battery

1 x Door/Window Contact Detector fitted with 5m cable

Fixing Kit (cable clips, screws and wall plugs)

IMPORTANT – Please read this manual carefully, in full, before commencing installation. You

will find installation easier if you follow these steps in the sequence shown.

SAFETY

Before proceeding with the installation, please note the following safety warnings:

DO NOT connect the mains supply directly to the products, this will cause permanent damage

to the products.

Control panel and Door/Window contact are for indoor use only. Avoid mounting location which can

expose the product to splashing or dripping liquid.

Always follow the manufacturer’s advice when using power tools and wear suitable protective

equipment (e.g. safety goggles) when drilling holes, etc. Before drilling holes in walls, check for

hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt.

Batteries should not be exposed to excessive heat such as sunshine, fire or the like; danger of

damage if battery is incorrectly replaced. Replace only with the same or equivalent type. (Do not

mix batteries type).

1. Installation -------------P. 2-3

2. Working modes --------- P. 4-5

 Door chime

 Instant alarm

 Delay alarm

3. Panic alarm -------------P.6

4. Change password -------P.6

5. Alarm Hold -------------P.6

6. Indications -------------P.7

1. Installation

1.1) Mounting of back-plate

a. Mark holes on the wall near the door with the back-plate.

b. Then use the screws provided to hang on the back-plate.

1.2) Installation of Main Unit

Make sure the Slide Switch is on

OFF

position.

Install the 9V battery into the battery compartment of the main unit

Secure the Main Unit top case / PCB

onto the back-plate.

Mounting

Holes

Need help?

Do you have a question about the Response Shed Alarm ML1 and is the answer not in the manual?

Summary

Response Shed Alarm User Manual

General Safety Warnings

Crucial safety instructions for installation and operation, emphasizing no mains connection and proper battery handling.

Installation Guide

Step-by-step instructions for mounting the back-plate and installing the main unit and door contact switch.

Working Modes Overview

Explanation of the different operational modes: Door Chime, Instant Alarm, and Delay Alarm.

Operating the Shed Alarm

Arming and Disarming Procedures

Instructions on how to arm the system when exiting and disarm it when entering the shed.

Panic Alarm Function

How to activate the alarm immediately using the panic button combination.

Changing the PIN Number

Procedure for changing the default four-digit PIN for enhanced security.

Alarm Hold Function

Details on how the alarm hold feature works and how to turn off the indicator light.

System Indications and Support

Understanding LED Indications

Explanation of what different Red LED blink patterns signify, such as alarm hold or low battery.

Troubleshooting and Reset

Guidance on issues like forgetting the PIN and how to reset the system to factory defaults.

Disposal and Guarantee Information

Instructions for responsible disposal of batteries and electronic waste, plus warranty details.

Customer Helpline

Contact information for installation and general advice regarding the Response Shed Alarm.