Restar solar RT Series - Mechanical; Electrical Specifications; Unpacking and Storage

www.restarsolar.com
３
3.0
MECHANICAL / ELECTRICAL
SPECIFICATIONS
Module electrical ratings are measured under Standard Test Conditions (STC) of 1000 W/m2 irradiance, with an
AM1.5 spectrum, and a cell temperature of 25°C. Detailed electrical and mechanical characteristics of Restar
Solar Renewable Energy Co.,Ltd crystalline silicon PV modules specifications can be found on
www.restarsolar.com Main electrical characteristics under STC are also stated on each module label. The
maximum system voltage for all module series is stated on data sheet.
Under certain conditions, a module may produce more current or voltage than under its Standard Test
Condition's rated power. As a result, the module short-circuit current at under STC should be multiplied by 1.25,
and a correction factor should be applied to the open-circuit voltage when determining component ratings and
capacities. Depending on your local regulations, an additional 1.25 multiplier for the short-circuit current (giving
a total multiplier of 1.56) may be applicable when sizing conductors and fuses.
4.0
UNPACKING AND STORAGE
PRECAUTIONS AND GENERAL SAFETY
· If modules are stored in an uncontrolled environment for less than 3 months, extra precautions should be
taken to prevent moisture exposure to connectors or sunlight exposure to modules.
· Unpack module pallets carefully, following the steps shown on the pallet. Unpack, transport and store the
modules with care.
Modules must always be unpacked by two people. Always use both hands when handling modules
Do not stand, step, walk and/or jump on modules
Stacks of modules should contain no more than 12 modules, and the frames should be
aligned.
· Do not place excessive loads on the module or twist the module frame.
· Do not use sharp instruments on the modules. Particular care should be taken to avoid module back sheets