Need help?Do you have a question about the Retekess T-AC01 and is the answer not in the manual?
Modify the programming code and set the main card for system access.
Procedure for adding a user card to the access control system.
Procedure for adding a password for a specific user.
Procedure for adding a Calgary Password.
Procedure for deleting a single user from the system.
Procedure for deleting all users from the access control system.
Procedure for changing existing passwords for users or the system.
Adjusting the delay time for door opening after authorization.
Resetting the system to its default factory settings.
Setting a universal password and managing card additions/deletions.
Default initial open code and programming code for the system.
Instructions for setting up shortcut access methods.
Steps to change the programming code and designate a master card.
Adding users who use cards for access control.
Adding users who use passwords for access control.
Adding users who require both card and password for access.
Procedure to remove a single user from the system.
Procedure to remove all users from the system.
Procedure for changing user passwords.
Adjusting the door opening delay time.
Resetting the system to factory default settings.
Setting a card for managing other cards (adding/deleting).
Setting a universal password for opening the door.
Procedure for exiting the system's programming mode.
Controlling the alarm function by swiping cards.
Configuring J1 for active/passive output and signal types.
Configuring J2 for system reset and password initialization.
Setting the default access control mode via GLED and GND.
Configuring the system for Wiggins 26 output.
Configuring the system for Wiggins 34 output.
Diagram illustrating normal power supply connections.
Instructions for connecting the red wire (+12V).
Instructions for connecting the black wire (Ground).
Instructions for connecting the yellow wire (Normally Open).
Instructions for connecting the gray wire (Common).
Instructions for connecting the violet wire (Normally Closed).
Instructions for connecting the brown wire (Exit Button).
Instructions for connecting the black wire (Ground).
Instructions for connecting the green wire (DO Signal Reader).
Instructions for connecting the white wire (D1 Signal Reader).
Instructions for connecting the blue wire (LED Signal Reader).
Instructions for connecting the orange wire (Copy data TXD).
Instructions for connecting the rose wire (Copy data RXD).
Important warnings and advice for using the device.
Troubleshooting common issues like card not opening doors or not reading.
General advice for maintenance, installation, and product updates.
Awareness of regulations for occupational RF exposure.
Information on radio licensing requirements and regulations.
Warnings against unauthorized modifications to the device.
Statement of compliance with EU directives.
Guidelines for proper disposal of electrical and electronic products.
Warning about small parts and the risk of choking for children.
Warning about damaged antennas and potential burns.
Caution regarding battery terminals and potential burns.
Prohibitions on charger usage and operation.
Recommendations to minimize risks associated with the device.
Notes on keeping the guarantee card and warranty service.
Conditions under which warranty coverage is voided.
General| Model | T-AC01 |
|---|---|
| Type | IP Access Controller |
| Power Supply | DC 12V |
| Communication Protocol | TCP/IP |
| Record Capacity | 100, 000 |
| Door Control | 1 Door |
| Operating Voltage | DC 12V |
| Access Control Output | Relay Output |
| Card Type | EM, MIFARE |
| Card Reader Interface | WG26, WG34 |
| Operating Temperature | -20℃ to +60℃ |
| Humidity | 10% to 90% |
| Supported Readers | Wiegand 26/34 |
| Network Interface | TCP/IP, RJ45 |
To Next Page
