SW1:3.2-4.1MHZ SW2:4.7-5.6MHZ
SW3:5.7-6.4MHZ SW4:6.8-7.6MHZ
SW5:9.2-10MHZ SW6:11.4-12.2MHZ
SW7:13.5-14.3MHZ SW8:15-15.9MHZ
SW9:17.4-17.9MHZ SW10:18.9-19.7MHZ
SW11:21.4-21.9MHZ
In the mode of SW, when any range is chosen, the mode of manual tuning will search in one
of ranges.
When the time is displayed, long press“ SUB BAND” to set MW manual tuning range and
numeric tuning range while switching between FM numeric tuning range. For details, please
refer to Article 7.3.1. There are different ranges because every potentiometer has an error,
it’s difficult to realize consistency between all radios. The frequencies beyond the range can
be displayed but cannot be received. There is a seamless connection between manual
tuning and “[ ]”it will automatically switch to manual tuning. VHF/AIR/WB doesn’t
support manual tuning, so it will switch to corresponding frequency after calculation with
algorithm through the potentiometer. When switching frequencies using shuttle and buttons,
it will automatically switch to numeric tuning.
7.3.3: In the mode of numeric tuning, switch between SW meter waves:
SW receiving frequency range: 3.2-21.95MHZ
Numeric tuning: in the mode of SW, lightly press “[ ]”to
show 11 SW meter waves: 3.20MHZ， 4.75MHZ，5.60MHZ， 7.35MHZ，9.90MHZ，
12.10MHZ，13.87MHZ, 15.80MHZ， 17.90MHZ，19.10MHZ， 21.85MH Lightly press“[ A ]”
to quickly switch and choose.
7.3.4: Switch between VHF wavelets: VHF receiving range: 30.00-199.975MHZ In order to
receive a channel more quickly, in the mode of VHF: there are 9 VHF wavelets. Lightly
press“[ A ] ”, LCD shows: 30.00MHZ, 50.00MHZ, 70.00MHZ, 90.00MHZ,
110.00MHZ,130.00MHZ, 150.00MHZ, 170.00MHZ, 190.00MHZ. Lightly press
“[ A ] ” to quickly switch and choose.
7.3.5: Switch between AIR wavelets: AIR receiving range: 118.00-138.00MHZ. In the mode
of AIR: lightly press“[ ] ”, LCD shows: 118.00MHZ, 123.00MHZ, 128.00MHZ,
133.00MHZ, 138.00MHZ. Lightly press“[ ] ” to quickly switch and choose.
7.3.6: Setting of VHF bandwidth:
In the mode of VHF, long press“[ ]” for 2 seconds to show current VHF bandwidth
5KHZ. When bandwidth is shown, lightly press“[ ]” to choose a bandwidth from 50KHZ,
100KHZ, 150KHZ and 200KHZ. After choosing a bandwidth, the radio will exit setting of
bandwidth automatically within 3 seconds and automatically confirm the bandwidth chosen
finally. Note: the factory default value of VHF-NFM is 5 KHZ. If 50KHZ, 100KHZ, 150KHZ or
200KHZ is chosen, the radio will receive signals in the mode of VHF-WFM demodulation.
09
To Next Page
Loading...
