9
hear the transmission.
3. To respond and talk to the person transmitting, press the
PTT
button within 5 seconds after the end of the
transmission.
4. The radio will resume scrolling through the channels ve seconds after the end of any received activity.
5. To stop scanning, briey press the button.
Scanning Notes:
1. If you press the
PTT
button while the radio is scrolling through inactive channels, the transmission will be on
the” home channel”. Scanning will resume 5 seconds after the end of your transmission. You may press the
button to stop scanning at any time.
2. If the radio stops on an undesired transmission, you may immediately resume the scan by briey pressing
or button.
3. If the radio repeatedly stops on an undesired transmission, you may temporarily remove that channel from the
scan list by pressing and holding or for 3 seconds. You may remove more than one channel in this
way.
4. To restore the removed channel(s) to the scan list, turn the radio o and then turn back on, or exit and re-enter
the scanning mode by pressing button.
5. You cannot remove the home channel from the scan list.
LED Lamp
Your radio has a built-in-LED Lamp.
Briey press the button once to ON the lamp, press again to OFF the lamp.
Automatic Power Save
For better battery life, your radio is designed to switch to Power Save mode when it has been no transmissions
after 5 seconds. The radio can receive transmissions in this mode.
To Next Page
Loading...
