Retrospec LENOX 2 - User Manual

LENOX 2, 3, 4, & 5 BIKE
HITCH RACK OWNER’S MANUAL
WARNING & CAUTION
Improperly installed rack or bikes can fall onto roadway
potentially causing a serious accident resulting in bodily
injury. Do not use rack on any vehicle where the rack cannot
be properly and safely installed.
Only install rack on vehicles with a 2” receiver hitch (no hitch adapters).
Never use on trailers, RV’s, hitch adapters, or front of vehicle.
Bikes must be secured to the rack using the supplied tie-downs and additional straps if
necessary (not supplied).
Check regularly during use that all bicycles remain secured and all bolts and pins are tight.
Bicycle tires should not be placed directly in front of an exhaust pipe. Tires can melt.
Not safe for Tandem Bikes, Recumbent Bikes, Motorized Bikes, or other non-standard bikes.
Max weight (evenly distributed): 5 Bike rack = 170lbs/77kgs, 4 Bike rack = 140lbs/63kgs, 3
Bike rack = 110lbs/50kgs, 2 Bike rack = 80lbs/36kgs
Do not block tail-lights or other car lights with bikes.
Drive carefully. Drive slowly over bumps. Do not Drive o-road.
Do not use the rack if any parts are missing. Contact Retrospec for replacement parts.
Bikes should never extend beyond side of vehicle.
Fold carry arms or remove rack when not in use.
MAIN PARTS: HARDWARE:
1 – Hitch Insert (“L”-shaped, inserts
into 2” hitch receiver on vehicle)
1 – Lower Mast (Retrospec logo
sticker)
1 – Upper Mast/Carrier Assembly
(Tie-Down Cradles attached)
Contents Hardware:
2 – 2 ½” bolts with nuts (14mm)
1 – 3” bolt with nut (14mm)
1 – 3 1/4” half-thread Anti-Rattle Bolt with
lock washer & Hairpin Cotter Pin (19mm)
1 – AntiRattle Adapter (minimizes wobble)
2 – 14mm/19mm wrenches
1 – 5mm hex wrench
ASSEMBLY INSTRUCTIONS * PLEASE READ INSTRUCTIONS ENTIRELY BEFORE BEGINNING ASSEMBLY *

Summary

Warning and Caution

Safety Precautions

Important safety warnings regarding rack installation, use, and potential road hazards. Emphasizes secure installation and proper bike loading.

Assembly and Installation

Assembling the Rack

Step-by-step instructions for assembling the main components of the hitch rack, including insertion and securing parts.

Installing Rack onto Vehicle

Detailed guidance on attaching the assembled rack securely to the vehicle's 2" hitch receiver using provided hardware.

Rack Operation Features

Folding the Rack

Instructions on how to fold the rack arms down when not in use for storage or easier vehicle access.

Tilting the Rack

Procedure for tilting the rack away from the vehicle to open the tailgate, with safety warnings.

Loading Bicycles

Bicycle Loading Guidelines

Steps and best practices for loading bicycles onto the rack, including positioning and securing methods.

Limited Warranty Information

Warranty Terms and Conditions

Details the limited lifetime warranty, coverage, exclusions, and procedures for warranty claims.

Retrospec LENOX 2 Specifications

General

Type	Bike Rack
Capacity	2 Bikes
Material	Steel
Color	Black
Assembly Required	Yes