10
GB
Car adapter
• Input voltage: 12.0V
• Input alternating current frequency: 50Hz
• Output voltage: 5.0V DC
• Output current: 0,9A
• Power output: max. 4,5W
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• Power supply unit
• Car adapter
• USB cable (cable length 1.0m)
TECHNICAL DATA
• Output: 3W LED
• Illuminant: COB LED´s
• Luminous flux: 300lm
• Luminous efficacy: 100lm/W
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 70
• Energy efficiency class: A+
• LED service life: 30.000h
• Beam angle: 80°
• IP protection class: IP20
• Protection class: III (S5)
• Protection class: II (S6)
• Ambient temperature: -10°C - 40°C
• Dimensions W x H x D: 40 x 390 x 35mm
• Weight: 150g
Power supply unit
• Manufacturer: Yuyao Simen Town Wanji Electrics Factory
Simen Industrial Zone, Yuyao City, Zhejiang, P.R.China
Commercial register number: 91330281768523343N
• Model code: WJG-Y050501000LU
• Input voltage: 230V
• Input alternating current frequency: 50Hz
• Output voltage: 5,0V DC
• Output current: 1,0A
• Output power (Po): 5,0W
• Average operational efficiency: 79,87%
• Efficiency at low load (10%): 76,00%
• Power consumption at no load: 0,071W
Work lamp
• Battery: Li-Ion (18650) 3,7V
1800mAh, 6,6Wh
• USB: Micro USB 2.0 Type B 5V max. 1A
LOADING PROCEDURE
1. Connect the power supply unit to the charging socket (Micro USB 2.0 type B) under the protective cover in the
handle.
2. A red indicator lamp lights up during the charging process. When the unit is fully charged, the indicator lights up
green.
3. Charging must be terminated after a maximum of 6 hours and the lamp must be disconnected from the mains or
when the indicator lights up green.
OPERATION/FUNCTION
All functions can be controlled via the central control knob ( ):
Press 1 time 50% luminosity of the main light
Press 2 times 100% luminosity of the main light
Press 3 times 100% luminosity of the head lamp
Press 4 times Switch luminaire off
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
To Next Page
