Instruction manual type CSM24U
Power Globe with 2 USB 2.0 ports
INSTALLATION
1. Ensure that all devices, which should be connected to the power globe, are switched off while connecting them.
2. Put the power globes plug into the power supply.
3. Output voltage USB ports: 5V, total output max. 2000mA
(Attention: Do not exceed 2000mA)
SAFETY
• For use in dry zones only.
• Observe the technical data of the socket when connecting external devices to avoid damage.
• Make sure that this product is kept out of the reach of children.
• This product must never be repaired by the user. Repairs must only be carried out by the manufacturer or an
authorized
service representative.
• Do not use device if damaged!
TECHNICAL DATA
• Voltage: 250V~, 50Hz, 16A, max. 3500W
• Cable: H05VV-F 3G1.5mm²
• Output voltage USB: 5V
• Total output: total max. 2000mA
2x 1000mA or 1x 2000mA
CLEANING
Clean the device with a dry cloth.
Do not use chemicals!
REV Ritter GmbH • Frankenstraße 1-4 • D-63776 Mömbris www.rev.biz
service-phone: +49 900 117-1070 • service-fax: +49 180 500 7410 • e-mail: service@rev.biz
ANL_CSM24U.indd 2 07.08.2017 15:45:30
To Previous Page
