EasyManua.ls Logo

REV Ritter TH400 - Introduction and Proper Use; Proper Use Guidelines; General Safety and Battery Instructions; General Safety Instructions

REV Ritter TH400
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
GB
Wood/ Volt/ Metal detector 3 in 1
Instruction manual
INTRODUCTION
Dear Customer,
We’d like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.
PROPER USE
GENERAL SAFETY INSTRUCTIONS
The product conforms to the appropriate European CE directives (S2).
The product is not suitable for rough use (e.g. construction sites)!
Handle this product carefully. It can be damaged by shocks, blows or by being dropped, even from a low height!
This product has no replaceable parts. Do not attempt to open or repair this product!
Please observe the technical specifications!
Please follow this instruction manual and keep it in a safe place!
Please pass on this instruction manual to a subsequent owner!
Not to be used by children!
Do not operate a defective product!
This product conforms to the appropriate European safety standards.
The product is not intended for use by persons (including children) whose physical, sensory or mental
abilities are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!
Only to be used by a qualified electrician (S4)!
The product is IP20 rated and suitable for use in dry interior spaces (S3).
Make sure that this product is kept out of the reach of children or unauthorised persons.
The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
The product is only designed for use with the appropriate batteries.
The product may only be used only for the purpose for which it is intended, in accordance with this user manual!
Do not open the housing (S5)!
Do not use in the immediate vicinity of flammable materials!
Do not immerse in water or other liquids!
Do not operate with wet hands!
Do not operate the product’s buttons with electrically conductive objects!
Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
Do not expose the product to direct sun and shield it from extreme heat!
The product’s keys must not be in permanent operation!
GENERAL INFORMATION
PROPER USE
The device uses electronic signals to locate the exact position of ceiling/wall joists, pipes and metal in masonry
and drywall. Once the outer edge of the set material is detected, the device sends visual and audible signals (LCD
display) that allow you to determine the central position.
SAFETY INSTRUCTIONS FOR BATTERIES
Do not short-circuit batteries.
An incorrect battery polarity can destroy the unit. Pay attention to the correct polarity when inserting the
batteries.
If you will not be using the product for a long time, remove the batteries.
Do not attempt to revive batteries or rechargeable batteries by heating or similar measures. Primary batteries
must not be recharged as this can lead to electrolyte leakage, explosion or fire.
Do not immerse batteries in water and store them in a dry, cool place, not a damp one.
Do not throw batteries into a fire, do not open them nor solder or weld them yourself.
Do not ingest batteries/rechargeable batteries, risk of burns from hazardous substances.
This product contains button cells. If the button cell is swallowed, severe internal burns can occur in as little as 2
hours and result in death.