The Settings Menu will look like the picture below
Unit – Displays KPH or MPH. You can
select your preference.
Speed Limit – Maximum speed at which
assistance to the motor will cease has
been set at 25Km/h as some countries
have set speed limits for electric bikes.
New Zealand speed limits for electric
bicycles are the same as for the road
rules for vehicles dependent upon the
speed zone that you are in riding in.
Please note that you must ride your
electric bike on the road and not the
footpath unless a cycle lane is available.
Backlight – The brightness of the LCD
backlight.
Wheel Size – Factory set at 26’’
(Do not Adjust)
Power O Delay – Time (in minutes)
at which the power will automatically
turn o if the bike is not being used. We
recommend that you leave this at the
factory setting.
NDW – Do not Adjust this.
Adjusting the Settings Menu: Once you
have entered the Settings Menu then Press
the + or – button to select the setting you
would like to adjust. The setting that is slowly
ashing is the setting that can be adjusted.
To adjust the setting, Press the Power/Mode
button once only.
Press the + or – button to adjust to the
desired setting. Once you have the desired
setting Press the Power/Mode button once.
When you have nished with the Settings
Menu, Press the Power/Mode button again
to bring you back to the main LCD screen
display.
To Next Page
Loading...