ADJUST THE AMOUNT OF PEDAL ASSIST
LCD UNIT BACKLIGHT AND LED HEADLIGHT
Press the + button to increase the amount of
pedal assistance. The higher the number the more
assistance is applied. Level 5 is the highest level of
assistance this bike has been set to.
Press the – button to decrease the amount of pedal
assistance. The lower the number, the lower the
level of assistance. Level 1 (as indicated in the photo
on the previous page) is the lowest pedal assist
setting.
You can lower the pedal assist down to 0, however
this will result in no pedal assistance when you ride
the bike.
Please Note: Each pedal assist level has a pre-set maximum speed. When the set speed
has been reached for the level of pedal assistance, the power to the hub motor will cease.
Should you want assistance from the motor then you either need to reduce the pedalling
activity and slow the bike, or press the + button to increase to a higher level of pedal assist.
Press and Hold the + button for 3
seconds to activate the LED headlight.
This action will also cause the LCD
Unit backlight to come on, to help light
the LCD screen. To turn the headlight
and backlight o, press and hold the +
button again for 3 seconds.
How to change between current
trip km travelled, and total distance
travelled: While the LCD Unit is on,
Press the Power/Mode button once
only, to switch between the current trip
km travelled and the total km travelled.
To reset the current trip meter back to zero,
Press and Hold the Power/Mode button and
the – button for 3 seconds
LCD/Controller Settings Menu: By Holding
the + and the - button at the same time for
3 seconds this will allow you to enter the
Settings Menu overleaf.
To Next Page
Loading...