REV MAX! - Teaching-in on the MAX! system; Teach-out;Reset

19
7. Teaching-in on the MAX! system
In order to enable communication
between MAX! Components, the
devices have to be taught-in to
one another.
• Start by switching the teach-in
partner (e.g. the MAX! Cube) to
teach-in mode.
• To activate teach-in mode on the
MAX! Window Sensor, press and
hold down the teach-in button (3).
The device LED starts to ash.
• Successful teaching-in of the
MAX! Window Sensor is conrmed by the LED light-
ing up once.
The radio-controlled window sensor can only be
taught in on one device (e.g. the MAX! Cube)
8. Teach-out/Reset
The MAX! Window Sensor can be reset to the initial state
manually. Restoring the initial state deletes all settings and
information about taught-in devices.
• First remove the batteries from the electronic unit.
• Wait 60 seconds.
• Press and hold down the teach-in button.
• Then re-insert the batteries.
• Press and hold down the teach-in button until the LED
starts to ash.
• Release the teach-in button; the factory settings are
restored.